Page
6
of
10
6 Assembly
A small amount of assembly is required when you receive your steam mop.
•
First, remove all the components from the packaging.
•
Take the Handle Grip and fit it to the top of the telescopic tube and fix in
place by screwing up and tightening the Tube Coupler.
•
Place the other end of the telescopic tube and place it into the top of the
Hinge Body hole.
•
At the lower end of the telescopic tube, press the Spring Loaded Pin
inward and at the same time, push the tube into the hole until the Pin
locates and locks into the location hole.
•
Adjust the height of the telescopic tube by sliding the locking button up,
pulling the tubes apart or pushing the tubes together, and releasing the
locking button when the desired height is reached.
7 Micro Fibre Pad
•
To fit the Micro Fibre Pad, place the Micro Fibre Pad on the floor with the
white Velcro strips facing up.
•
Lift the steam mop up and position centrally over the Micro Fibre Pad and
then lower down.
•
The Velcro strips will attached itself to the base of the Steam Mop.
•
To remove the Micro Fibre Pad, ensure the steam mop is unplugged,
empty of water and cool.
•
Grasp the corner of the Micro Fibre Pad and peel back to release the
Velcro strips.
Note
: Ensure the Micro Fibre Pad is fitted before use.
