32
SINUS motorglider
www.pipistrel.si
REV. 0
33
SINUS motorglider
www.pipistrel.si
REV. 0
Normal procedures
In-cockpit preflight check-up
Instrument panel and instruments:
checked
Fuses:
screwed in position
Battery disconnection lever:
in position for battery operation (lever deflected towards the firewall)
Master switch OFF (key in full left position):
no control lights and/or electronic instrument activity
Master switch ON (key in full right position):
control lights and electronic instrument active
Make sure you have set all instruments to correct initial setting.
Main wing spars and connectors:
no visible abnormalities of metal parts, spars, pins and bolts; all
bolts and nuts in position and tightened
Fuel hoses, pitot-static lines and electrical cables:
correctly connected and in position
Transparent plastic providing visual fuel quantity monitoring:
clean with no cracks
Safety harness:
undamaged, verify unobstructed harness opening; fastening points intact
Glass doors and windshield:
perfect closing at all three points, smooth opening, hinges firmly at-
tached; glass immaculately clean with no cracks.
Flap handle:
button spring firm, locking mechanism working properly, smooth movement along full
deflections, no free play or visible damage.
Spoilers (Airbrakes) handle:
full-up and locked
Radio wiring:
test the switches, check connectors and headset, perform radio check
Injection oil quantity (optional oil injection pump):
sufficient for the planned flight duration
Battery (some models):
firmly in position, check water level (if not dry version), joints clean with
wires connected
Emergency parachute release handle (optional):
safety pin removed.
Make sure unobstructed access is provided.
Normal procedures
and recommended speeds
To enter the cabin first lift the glass door all the way to the bottom wing surface. The silver knob
will grab and secure the glass door in position. Sit onto the cabin’s edge and support your body by
placing hands onto this same cabin edge. Drag yourself into the seat lifting first the inner and then
the outer leg over the control stick. Immediately after having sat into the seat, check rudder pedals’
position to suit your size and needs. Bring the pedals closer or further away by removing the pin in
between the pedals and slide them to desired position. Do not forget to re-insert the pin in order to
secure pedals in position.
To lower the door DO NOT attempt to grab and pull door’s handle but gently pull the silver knob
instead. To close the door securely, rotate the handle so that it locks (click here to see picture) and
verify that all three closing points are secured.
Fasten the safety harnesses according to your size.
WARNING!
The safety harness must hold you in your seat securely. This is especially impor-
tant when flying in rough air, as otherwise you may bump into the tubes and/or spars overhead.
Summary of Contents for Sinus 503
