Piper Cherokee LANCE, Service Manual

Page: 757 / 854

PIPER CHEROKEE SIX / LANCE SERVICE MANUAL
03/27/08 III - INSPECTION
4C23
TABLE III-I. INSPECTION REPORT - PA-32-260/300 (cont.)
Inspection
NATURE OF INSPECTION Interval (Hrs)
50 100
E. WING GROUP (CONT.)
11. Inspect flap hinge bolts for condition and security. Replace as required............... O
12. Lubricate per Lubrication Chart, Section II ........................................................... O O
13. Inspect wing attachment bolts and brackets for security, corrosion and condition.
(See Note 23.) ........................................................................................................ O
14. Re-torque wing forward and aft spar attach bolts per Figures 4-1 and 4-1B......... O
15. Inspect fuel tanks and lines for leaks and water. (See Note 14.)............................ O
16. Inspect fuel tanks for minimum octane and capacity markings............................. O
17. Inspect fuel tank vents for condition, security, and operation ............................... O
18. Inspect all controls, air ducts, electrical leads, lines, and attaching parts
for security, routing, chafing, deterioration, wear, and correct installation ........... O
19. Install inspection plates and fairings...................................................................... O
F. LANDING GEAR GROUP
1. Check oleo struts for proper extension and evidence of fluid leakage.
(See Landing Gear System, Section II.).................................................................
O O
2. Inspect nose gear steering control and travel ......................................................... O
3. Remove wheel fairings........................................................................................... O
4. Inspect wheel alignment ........................................................................................ O
5. Put airplane on jacks. (Refer to Section II.)........................................................... O
6. Inspect tires for cuts, uneven or excessive wear, and slippage .............................. O
7. Remove wheels; clean, inspect, and repack bearings ............................................ O
8. Inspect wheels for cracks, corrosion, and broken bolts ......................................... O
9. Check tire pressure. (See Table II-I.) ..................................................................... O O
10. Inspect brake lining and disc for condition and wear.
(See Note 24 and Paragraph 6-31.) ........................................................................ O
11. Inspect brake backing plates for condition and wear ............................................. O
12. Inspect brake lines for condition and security ....................................................... O
13. Inspect shimmy dampener operation ..................................................................... O
14. Inspect gear forks for damage................................................................................ O
15. Inspect gear struts, attachments, torque links, and bolts
for condition and security. (See Note 25.) ............................................................. O
16. Inspect torque link bolts and bushings. Rebush as required. (See Note 22.) ........ O
17. Inspect wheel fairings and attachments ................................................................. O
18. Inspect all hydraulic lines, electrical leads, and attaching parts for condition
and security (i.e. - routing, chafing, damage, wear, etc.) ...................................... O
19. Lubricate per Lubrication Chart, Section II ........................................................... O O
20. Install wheel fairings.............................................................................................. O
21. Remove airplane from jacks .................................................................................. O