Pipeline VTC DUAL, Instruction Manual

Page: 4 / 8

SWITCH BETWEEN DIFFERENT MODES:
Press the fire button 3 times to enter the settings menu. Press the right regulatory button to switch between TEMP, TCR,
POWER and BYPASS modes. Press the fire button to confirm.
For TEMP or TCR mode, while flashing, press the left regulatory button to enter its subsidiary menu to set: VT, PWR, COIL
and AMP. When adjusting VT, press the right regulatory button to switch between Temp Ni, Temp Ti and Temp SS316/ M1,
M2 and M3 modes. Press the fire button to confirm. When the AMP row is flashing, press the right button to switch between
AMP, PUFF and TIME.
PWR-MODE:
Power mode (VW):
Using the control buttons you can increase or decrease the power. This can be accelerated by holding the button.
BYPASS-MODE:
Bypass mode:
In Bypass mode, you can vape with the device unregulated. The device delivers the voltage of the battery to the
atomizer. The pre-existing safety functions remain.
TEMP-MODE:
Temperatur mode:
To use the TEMP mode, you need an atomizer with a coil made out of a temperature-control compatible wire.
Use the control buttons to increase or decrease the temperature (100-315°C or 200-600°F).
This can be accelerated by holding the button pressed.
Calibrating the resistance in TEMP mode (lock mode):
Press the fire button three times to enter the menu. Press the left control button twice until the third line flashes.
Press the right control button to calibrate the resistance. The lock icon (Lock) appears on the display when the atomizer
is calibrated. NOTE: Please calibrate your atomizer at room temperature (about 20°C) so the correct
„base resistance“ can be found.