04 EXTENDED FUNCTIONS MENU
Bat Min:
Setting the cut off voltage of
the battery (2.5 to 3.0V - Factory
setting: 2.7V)
Cycles:
Number of puffs since
resetting the counter
Temp Cof up:
increasing the wire-temperature
coefficient (default: 320) *
Temp Cof down:
Decreasing the
wire-temperature coefficient
(default: 320) *
Power Lim:
Set the power limit. The intensity
of „Power Boost“ is also defined
by setting the Power Limit
(factory setting: 40W)
HP Set:
Heat Protection mode selected
(More information at
06 - Factory setting: 6)
Power Boost:
Power Boost mode selected
(More information at
06 - Factory setting: 3)
Lumen:
Changes the brightness of the
display. 1 is the darkest value, 6
the brightest. (Default: 4)
Time:
Vaping time in H: MM: SS
since resetting the counter
SwOff Time:
Automatic shutdown of the device
after a given time. When setting
the switch off time, the value in
the display appears in „minutes“.
(Factory setting: 5 minutes)
Energy:
Energy consumption since
resetting the counter
On Click:
Sets the number of clicks to
activate a switched off device.
(Factory setting: 0 - Ready for
vaping)
BatCap:
Capacity of consumed battery
since reset (Capacity of the
battery if synchronized with the
replacement of the battery)
Reset Cntr:
Reset the counter
TotCycl:
Total amount of puffs
on PIPELINE PRO 2 PLUS
(not resettable)
TotTime:
Total vaping time of
PIPELINE PRO 2 PLUS
(not resettable)
* The temperature coefficient of the wire
material used for correct operation in the range
100-650: 320 = Dicodes wire (Resistherm),
620 = nickel, approximately 105 = Stainless Steel,
350 = titanium,
480 = tungsten (value = coefficient * 10E + 5K)
MenuOn Click:
Sets the number of clicks
needed to display the menu.
(Factory setting: 1
Click Speed:
Key velocity
(Animation appears at 4 and 5)
(Factory setting: 3)
Half Watt:
Power increment 1W / 0.5W
(<20W), 2W / 1W (20-40W)
(factory setting 1)
Temp Unit:
Unit of temperature display
in ° C or ° F (Default ° C)
Display Mode:
When (1) is selected the display shows during vaping and for 4 seconds after.
When (0) is selected the display shows the most recently calculated figures for
4 seconds after vaping but remains off during vaping. (Factory setting is 1).
Display Dir:
Display orientation for right or
left hand (default: R)
Expert Mode:
Unlock (1) or Disable (0) the HP,
BO and bypass modes
(factory setting: 1)
Reset:
Reset to factory settings
