9
Engb
Assembly of clusters using the CP-XY15DF1 Dual Enclosure Flying Plate set
Using the supplied M10 socket head bolts, bolt through the CP-XY15DF1 plate into
the enclosures. Ensure that both the flat and spring washers are used — the flat
washer should be in contact with the plate. Once the desired angles of the loud-
speakers are set, tighten the bolts to lock in place. Then turn the cluster over and
repeat the process on the bottom. Use the top points on the XY-152 enclosures as a
secondary safety feature.
Attachment of wall mount brackets
!
Four holes (M8) for wall mount brackets are provided on the rear of the XY-152.
!
Hole layout (pitch): 127 mm × 70 mm (5 in. × 2.8 in.)
!
Be sure to use wall mount brackets that have enough strength to be able to withstand the weight of the XY-152.
To rotate the HF waveguide
1 Using a 4 mm Allen key, unscrew the six M6 screws in the top and bottom of the enclosure (3 at each end). Gently remove the grille from the front of the enclosure.
2 Using a 4 mm Allen key, remove the eight countersunk bolts holding the HF waveguide in place.
3 Lift the waveguide up and rotate to the desired position.
4 Reinstate the socket-head bolts and retighten. Avoid over-tightening as this may crack the waveguide.
5 Reinstate the grille by gently placing it in place over the front of the loudspeaker. Replace the six M6 screws to secure it in place.
Mounting
and rigging
options