XV-HTD530
122
1
2
3
4
1
2
3
4
C
D
F
A
B
E
AF Assy
5
1
Remove the bonnet and tray cap. (See Step
¥
.)
Reattach the Table Mechanism Section.
(Be sure to secure it in place with screws.)
Turn the AF Assy with the Table Mechanism Section
attached to the upright position.
Arrange the cables as shown in the photo below.
14
13
10
12
11
Connect the AF Assy with the AMP Module Section using
a jig cable.
2
Remove the Front Panel Section. (See Step
ø
.)
3
Remove the Table Mechanism Section. (See Step
π
.)
4
Remove the DVDM Assy. (See Step
π
.)
5
Remove the AMP Module Section. (See Step
[
.)
7
Remove the four screws.
6
Remove the DVD Angle HTM by removing the one screw.
8
Remove the five screws.
9
Loosen the cord holder.
Reattach the DVDM Assy.
Rear Panel
AF Assy
DVD TRADE
Assy
DVD Angle HTM
AF Assy
Table Mechanism Section
AMP Module Section
PRIMARY Assy
7
A
A
A
8
9
8
8
8
14
12
13
8
7
7
7
6
Note on handling the rear panel
During diagnosis, be sure NOT to remove the four screws
marked
A
in the above photo. This unit will not operate if the
Audio Output connectors and the Speaker Output connectors of
the AF Assy are separated from the rear panel, because that
would break the circuit.
Jig cable
(GGD1315)
