Bluetooth
®
Audio playback
28
En
10
Note
• This unit will be displayed as “Pioneer X-CM66” on all
Bluetooth
capable devices that you have.
Pairing will start.
• Place the
Bluetooth
capable device close to the unit.
• Please refer to the user’s manual for your
Bluetooth
capable device for details on when pairing can be
performed and the procedures required for pairing.
• When PIN code entry is requested, enter “
0000
.” (This
unit does not accept any PIN code setting other than
“
0000
.”)
4
Confirm on the
Bluetooth
capable device
that pairing has been completed.
If pairing with the
Bluetooth
capable device has been
completed correctly, the name of the
Bluetooth
capable
device will be displayed on the front panel of the unit. (Only
single-byte alphanumeric characters can be displayed. Any
character that cannot be displayed will be indicated by a
“
∫
”.)
Listen to music on the unit from a
Bluetooth
capable device
1
Press the
.
The unit will switch to
Bluetooth
input.
2
A
Bluetooth
connection will be created
between the
Bluetooth
capable device and the
unit.
Procedures for connecting to the unit should be performed
from the
Bluetooth
capable device.
• Please refer to the user’s manual for your
Bluetooth
capable device for details of the connection procedures.
3
Playback music from the
Bluetooth
capable
device.
Note
• When
Bluetooth
capable devise is not connected and
no operations have been performed for more than 20
minutes, the unit will automatically power off. In this
case it is required that the Auto power off is switched to
ON
.
• Auto power off can be switched to
ON
/
OFF
(page 37).
Starting by
Bluetooth
When this unit is in standby mode and operations to connect
with this unit are made from a device with Bluetooth that has
been paired with this unit, this unit turns on automatically with
Bluetooth input selected.
1
Press MENU on the remote control.
2
Press
/
until “Network Standby” is
displayed, then press ENTER.
3
Press
/
to switch auto power off setting
ON/OFF.
• Initial setting is set to
ON
.
Note
• Power consumption in the standby mode increases
when this function is
ON
.
Connection while in Network Standby mode with
Bluetooth
capable device
When connection history (pairing has already been
conducted) with a
Bluetooth
capable device exists for the
unit during Network Standby, the unit can receive a
connection request directly from the connection history.
The unit will start using the
Bluetooth
function, and connect
with a
Bluetooth
capable device.
Even devices that have already been paired with this unit will
not connect during Network Standby in the following cases.
In such cases, delete pairing history from the
Bluetooth
wireless technology device and perform pairing again.
• Up to 8 pairing history can be recorded with this unit. If
connecting to a
Bluetooth
wireless technology device
over 8 units, the oldest pairing history will be deleted.
• If the settings are reset to the factory setting, all pairing
history will be deleted.
SN29402598_X-CM66D_En.book 28 ページ ２０１６年８月２日 火曜日 午後４時８分
