Page 7
2. Electrical parts (Antistatic gloves must be worn.)
Note: Remove the front panel (refer to 1. Front panel) before disassembling electrical parts.
Procedure
Illustration
1) Cut the ribbon by a shear, then pull
out the coil temperature sensor (T2)
(see
Figure
14).
2) Remove one fixing screw of the
electronic control box and two screws
used for the ground connection (see
Figure
14).
3) An upward force is maintained until
the cover of electronic control box is
removed (see
Figure
15).
Figure 14
Figure 15
Note: This section is for reference only. Actual unit appearance may vary.
Figure
11-1
Ribbon
T2 Sensor
Ground Screws
