Setting up the receiver
06
32
En
4
Use
’
or
‘
to adjust the setting.
The setting is entered automatically.
5
Repeat steps 3 and 4 to set other
surround modes.
6
When you’re done, press ENTER to exit.
The setting display is automatically exited
after 3 minutes of inactivity.
Speaker setting
• Default setting:
S
(all speakers)
You must let the receiver know how many
speakers you have, and how big they are. The
size you choose (large or small) determines
how much bass is sent from the receiver to the
speakers.
In the display,
F
,
C
, and
S
refer to front, center,
and surround speakers respectively. Speaker
size is denoted as
L
for large speakers,
S
for
small speakers, and (asterisk) if no speaker is
connected.
•
Cycle through the available choices
using
’
or
‘
and choose a configuration
that matches your speaker setup.
One of the following configurations should
match your setup:
FL-CL-SL
FL-CL-SS
FL-CL-S
FL-CS-SL
FL-CS-SS
FS-C -SS
FS-CS-S
FS-CS-SS
FL-C -S
FL-C -SS
FL-CS-S
FS-C -S
FL-C -SL
• If the cone size (diameter) of the speaker is
larger than 15 cm, set the speaker size to
L
.
• If you’re not using a subwoofer, we
recommend setting the front speakers to
L
.
Subwoofer setting
• Default setting:
YES
You can choose whether the subwoofer is used
or not. Use the plus (
PLUS
) setting for extra
bass.
•
Use
’
or
‘
to select a subwoofer
setting:
YES
Sends bass frequencies from the small (
S
)
speakers to the subwoofer.
PLUS
Sends bass frequencies from all speakers to the
subwoofer (
L
speakers will also output bass).
NO
No bass frequencies are sent to the subwoofer.
