Pioneer VSX-C501-S, Service Manual

Page: 110 / 111

VSX-C501-S
110
1 2 3 4
1 2 3 4
C
D
F
A
B
E
ADVANCED SURROUND
Use to select an ADVANCED SURROUND mode for
the current source.
SOUND MODE
Use to select a SOUND MODE for the current
source.
DIALOG
Press to switch on/off DIALOG (dialog
enhancement).
10 MUTE
Press to mute all output. Press again (or adjust the
volume using the
MASTER VOLUME control) to restore
the sound.
11 SIGNAL SELECT
Press to select the type of input signal for the current
input (
DVD , STB , DVR/TV and FRONT ).
12 MASTER VOLUME
Use to adjust the volume.
13 MCACC SETUP
Press to start MCACC (Multichannel Acoustic
Calibration) setup.
14 SYSTEM SETUP
Press to access the SYSTEM SETUP menu to make
detailed receiver settings.
15 Cursor keys and ENTER
Use to navigate menus and select options/execute
commands.
16 SBch MODE
Use to select the surround back channel mode.
17 DIMMER
First press RECEIVER , then press DIMMER repeatedly to
change the brightness/switch off the front panel display.
The display will light brightly for about two seconds when
you operate the receiver with the display off or dimmed.
(Note that the master volume indicator always remains
lit, even when the rest of the display is off.)
18 Playback controls
Playback controls for external components, such as DVD
and CD players.
Functions printed in blue control the built-in tuner; other
functions control other external equipment.
19 Number buttons
Use for numerical input of track numbers, radio
frequencies, and so on.
20 C/–
Use to change channels on a satellite receiver, cable box,
VCR or DVR.
21 TV CONTROL buttons
Use to control your TV (after setting up the remote control
to work with your TV).
The default preset codes are shown in the table.
Input/control mode
select button Preset
code Component
(manufacturer)
DVD 020 DVD (Pioneer)
STB 200 STB (Pioneer)
DVR/TV 466 DVD recorder
(Pioneer)
VIDEO 600 TV (Pioneer)
FRONT 100 LD (Pioneer)
FM/AM n/a (built-in tuner)
TV CONTROL 600 TV (Pioneer)
Resetting all remote control settings
This restores all presets to the factory defaults. See Using
the remote control with other components for
the default remote settings.
•
Press RECEIVER and number button "0" (zero) at
the same time. Keep them pressed for about 3
seconds.
The LED on the remote control blinks three times
indicating all the preset codes and the Remote Direct
setting have been reset to the factory defaults.