Pioneer VSX-95, Operating Instructions Manual

Page: 50 / 164

50
Connecting your equipment (In case of VSX-45)
04
Connecting an MHL-compatible device
An MHL-compatible mobile device can be connected to enjoy 3D/Full-HD videos, high quality multi-channel
audio, and photos etc., with charge the battery on the receiver. Use the MHL cable to connect the device.
/MHL BD 5
1 5 -
4 3 2 1
(OUTPUT 5 V
0.9 A MAX)
ARC CONTROL
(DVD) (SAT/CBL)
HDMI IN OUT
/MHL BD 5 4 3 2 1
(OUTPUT 5 V
0.9 A MAX)
ARC CONTROL
(DVD) (SAT/CBL)
ASSIGNABLE
MHL enabled
device
MHL cable
% Switch the receiver into standby then use the MHL cable to connect your MHL enabled
device to the MHL terminal on the rear panel of this receiver.
!
To automatically switch to the MHL input when an MHL-compatible device is connected, see MHL Setup on
page 112 .
!
The MHL-compatible device is recharged whenever it is connected to this unit. (Recharging is enabled only
when the unit’s power is turned on.)
!
For instructions on playing the MHL-compatible device, see Playing an MHL-compatible device on page 69 .
! Do not place the MHL device on this unit which has the power turned on.
Connecting an IR receiver
If you keep your stereo components in a closed cabinet or shelving unit, or you wish to use the sub zone remote
control in another zone, you can use an optional IR receiver (such as a Niles or Xantech unit) to control your
system instead of the remote sensor on the front panel of this receiver.
! Remote operation may not be possible if direct light from a strong fluorescent lamp is shining on the IR
receiver remote sensor window.
! Note that other manufacturers may not use the IR terminology. Refer to the manual that came with your com-
ponent to check for IR compatibility.
! If using two remote controls (at the same time), the IR receiver’s remote sensor takes priority over the remote
sensor on the front panel.
1 Connect the IR receiver sensor to the IR IN jack on the rear of this receiver.
1
OUT
IN
IR
CONTROL
IN
IR
Closet or shelving unit
Non-Pioneer
component
IR receiver
OUT
IN
IR
CONTROL
2 Connect the IR IN jack of another component to the IR OUT jack on the rear of this receiver
to link it to the IR receiver.
Please see the manual supplied with your IR receiver for the type of cable necessary for the connection.