Basic Setup
3
3
17
9
Wait for the test tones to finish.
A progress report is displayed on-screen while the
receiver outputs test tones to determine the speakers
present in your setup. Try to be as quiet as possible
while it’s doing this.
•
For correct speaker settings, do not adjust the volume
during the test tones.
10
Confirm the speaker configuration.
The configuration shown on-screen should reflect the
actual speakers you have.
•
With error messages (such as
Too much ambient
noise
) select
RETRY
after checking for ambient
noise (see
Other problems when using the Full Auto
).
If the speaker configuration displayed isn’t correct, use
/
to select the speaker and
/
to change the setting. When
you’re finished, go to the next step.
If you see an error message (
ERR
) in the right side column,
there may be a problem with the speaker connection. If
selecting
RETRY
doesn’t fix the problem, turn off the power
and check the speaker connections.
11
Make sure “OK” is selected, then press
ENTER
.
If the screen in step 10 is left untouched for 10 seconds
and
ENTER
is not pressed in step 11, the Full Auto
MCACC setup will start automatically as shown.
A progress report is displayed on-screen while the
receiver outputs more test tones to determine the
optimum receiver settings for channel level, speaker
distance and Acoustic Calibration EQ.
Again, try to be as quiet as possible while this is
happening. It may take 1 to 3 minutes.
12
The Full Auto MCACC setup has finished, then the Home
Menu screen is automatically displayed.
The settings made in the Full Auto MCACC setup should
give you excellent surround sound from your system, but
it is also possible to adjust these settings manually using
the
Home Menu
(starting on
).
Note
•
Depending on the characteristics of your room, sometimes
identical speakers with cone sizes of around 12 cm (5
inches) will end up with different size settings. You can
correct the setting manually using the
.
•
The subwoofer distance setting may be farther than the
actual distance from the listening position. This setting
should be accurate (taking delay and room characteristics
into account) and generally does not need to be changed.
Other problems when using the Full Auto
MCACC setup
If the room environment is not optimal for the Full Auto
MCACC setup (too much background noise, echo off the
walls, obstacles blocking the speakers from the microphone)
the final settings may be incorrect. Check for household
appliances (air conditioner, fridge, fan, etc.), that may be
affecting the environment and switch them off if necessary. If
there are any instructions showing in the front panel display,
please follow them.
•
Some older TVs may interfere with the operation of the
microphone. If this seems to be happening, switch off the
TV when doing the Full Auto MCACC setup.
1.Full Auto MCACC
Now
Analyzing
Environment Check
Ambient Noise
Speaker YES/NO
Return
1.Full Auto MCACC
Check
Return
9:NEXT
Front
Center
Surround
Subwoofer
[ YES ]
[ YES ]
[ YES ]
[ YES ]
OK
1.Full Auto MCACC
Now
Analyzing
Surround Analyzing
Speaker System
X.Over
Speaker Distance
Channel Level
Acoustic Cal EQ
Return
