TAD-R1
8
1
2
3
4
1
2
3
4
C
D
F
A
B
E
3.3 SPEAKER SYSTEM
8
7
1
3
8
21 (x4)
3
23 (x8)
6
9 (x3)
9 (x3)
19
14
25 (x6)
16
11
18 (x6)
18 (x6)
24 (x6)
25 (x6)
15
12
17
20
9
LPF
12
Rubber cushions
Stick the packing onto
the back of the trim ring.
Pass the cables through the holes on the rear
panel of the cabinet and wind the packing at
the designated places. Adjust for the thickness
of the packing and cut off the unnecessary
remaining packing material.
Connect the cables of the NW Assy, then push
the cables back into the cabinet so that the
holes are properly filled with the packing.
Fit the Grill Assy into the trim ring (WF) so that the curves of the
Grill Assy and the baffle correspond. If fitting is too tight or loose,
adjust for the thickness of the tape wound around the Grill Assys.
Push the gasket into between
the CST trim ring and the hole
of the baffle plate.
Be careful that this ring is level
with the trim ring.
CST ASSY
Stamp of
Serial No.
After removing the separator, attach
the packing to the baffle plate.
Fit the cutouts around the outer
circumference of the packing with the
rubber cushions. The cutouts around
the inner circumference should be
located at the positions 45° rotated
clockwise or counterclockwise from
the vertical line.
After removing the separator, attach
the pieces of the packing to the
baffle plate so that the end of one
piece adheres to the end of another
piece without a gap.
<Attachment of the packing>
<Rear of the cabinet>
<Rear of the cabinet>
