Pioneer SX-10AE, Instruction Manual

Page: 13 / 28

13 En
> Before Start > Part Names > Install > Playback
Setup | Others
Listening to the AM/FM Radio
You can receive AM/FM radio stations on
this unit with the built-in tuner. Perform the
following procedure when the unit is on.
∫
Tuning into a Radio Station
Tuning Automatically
The unit is set to the auto-tuning mode by
default. If the signal from a radio station is
weak, perform the procedure for "Tuning
Manually" in the next section. Note that if
you tune manually, the reception for FM
broadcasts will be monaural rather than
stereo, irrespective of the sensitivity of the
reception.
1. Press AM or FM (e) on the remote
controller.
2. When you press the cursor Up/Down
buttons (c) on the remote controller,
automatic tuning starts, and searching
stops when a station is found. When
tuned into a radio station, the
"
1
TUNED
2
" indicator on the display
lights. When tuned into a stereo FM
radio station, the "FM STEREO"
indicator lights.
Tuning Manually
If you tune manually, the reception for FM
broadcasts will be monaural rather than
stereo, irrespective of the sensitivity of the
reception.
1. Press AM or FM (e) on the remote
controller.
2. After pressing SETUP (d) on the remote
controller, use the cursor Up/Down
buttons (c) to select "Mono" in "Tuner
Setting" - "Tuning Mode", and then press
ENTER to set.
3. While pressing the cursor Up/Down
buttons (c) on the remote controller,
select the desired radio station.
0
The frequency changes by 1 step
each time you press Up/Down
buttons. The frequency changes
1 2
Mode : Mono
continuously if the button is held down
and stops when the button is
released.
Tuning into Stations by Frequency
It allows you to directly enter the frequency
of the radio station you want to listen to.
1. Press AM or FM (e) on the remote
controller.
2. Press DIRECT TUNING (b) on the
remote controller twice.
3. Using the number buttons (a) on the
remote controller, enter the frequency of
the radio station within 8 seconds.
0
To enter 87.5 (FM), for example,
press 8, 7, 5 or 8, 7, 5, 0. If the
entered number is incorrect, press
DIRECT TUNING twice again and re-
enter the number.
AM Frequency step setting (European
and Australian models):
Press SETUP on the remote controller,
then use the cursor buttons and ENTER on
the remote controller to select "Tuner
Setting" - "AM Freq Step", and select the
frequency step for your region. Note that
when this setting is changed, all radio
presets are deleted.
e
c
a
d
b
SN29403247_SX-10AE_En_1707XX.book 13 ページ ２０１７年７月１９日 水曜日 午後１時５９分