+6
to
–
4
(or
–
6
) is displayed as the equalizer
curve is increased or decreased.
#
The actual range of the adjustments are differ-
ent depending on which equalizer curve is se-
lected.
#
The equalizer curve with all frequencies set to
0
cannot be adjusted.
Adjusting 7-band graphic equalizer
For
Custom1
and
Custom2
equalizer curves,
you can adjust the level of each band.
!
A separate
Custom1
curve can be created
for each source. (The built-in CD player and
the multi-CD player are set to the same
equalizer adjustment setting automati-
cally.) If you make adjustments when a
curve other than
Custom2
is selected, the
equalizer curve settings will be memorized
in
Custom1
.
!
A
Custom2
curve can be created common
to all sources. If you make adjustments
when the
Custom2
curve is selected, the
Custom2
curve will be updated.
1
Recall the equalizer curve you want to
adjust.
See
Recalling equalizer curves
on the previous
page.
2
Use MULTI-CONTROL to select 7-band
graphic equalizer adjustment.
Frequency and the level (e.g.,
50Hz +4
) ap-
pears in the display.
3
Push MULTI-CONTROL left or right to
select the equalizer band to adjust.
Each time
MULTI-CONTROL
is pushed left or
right, equalizer bands are selected in the fol-
lowing order:
50Hz
—
125Hz
—
315Hz
—
800Hz
—
2kHz
—
5kHz
—
12.5kHz
4
Push MULTI-CONTROL up or down to
adjust the level of the equalizer band.
Each time
MULTI-CONTROL
is pushed up or
down, the level of the equalization band in-
creases or decreases.
+6
to
–
6
is displayed as the level is increased
or decreased.
#
You can then select another band and adjust
the level.
5
Press BAND to cancel the 7-band gra-
phic equalizer adjustment.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1
Use MULTI-CONTROL to select LOUD.
2
Press MULTI-CONTROL to turn loudness
on.
Loudness level (e.g.,
Mid
) appears in the dis-
play.
#
To turn loudness off, press
MULTI-CONTROL
again.
3
Push MULTI-CONTROL left or right to
select a desired level.
Each time
MULTI-CONTROL
is pushed left or
right, level is selected in the following order:
Low
(low)
—
Mid
(mid)
—
High
(high)
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
1
Use MULTI-CONTROL to select Sub W.1.
#
You can also select the subwoofer setting
menu by pressing
SW
on the unit.
2
Press MULTI-CONTROL to turn subwoo-
fer output on.
Normal
appears in the display. Subwoofer out-
put is now on.
#
To turn subwoofer output off, press
MULTI-CONTROL
again.
Operating this unit
En
27
English
Section
02
