10
En
2 Plug the supplied AC adapter into the DC IN socket on the back of the unit.
STZ-D10T only:
To use the AC adapter, open the outlet cover on the back of the unit.
3 Plug the AC adapter into a power outlet.
To AC outlet
AC adapter
(supplied)
DC IN 12 V
AUX IN
5V 500mA
USB
PC connect
PHONES
STZ-D10T
Removing the power plug
Push down on the
PUSH
button and slide the power plug out of the guide rails of the power adapter as shown in the figure below.
Installing batteries
WARNING
Incorrect use of batteries may result in such hazards as leakage and bursting. Observe the following precautions:
!
Never use new and old batteries together.
!
Do not mix and use nickel hydride battery with different charges.
!
Insert the plus and minus sides of the batteries properly according to the marks in the battery case.
!
Batteries with the same shape may have different voltages. Do not use different batteries together.
!
When disposing of used batteries, please comply with governmental regulations or environmental public institution’s rules that apply in your
country/area.
!
Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a heater. This can cause batteries to leak,
overheat, explode or catch fire. It can also reduce the life or performance of batteries.
CAUTION
STZ-D10T only:
Leaving the battery cover off entirely or insufficiently tightening it will comprise drip proofing. Make sure that the battery cover is firmly
attached in place.
1 Loosen the LOCK screw on the battery cover, then remove the cover.
Use a coin to rotate the LOCK screw about 10 turns in a counter clockwise direction (opposite direction to the arrow shown on LOCK).
Place your finger in the groove and release the hooks located on both sides to open the battery cover.
LOCK
LOCK
Hook
