13
Getting R
eady
&KHFNLQJ2SHUDWLRQRIWKH6HQVRUV
7
Install the right transmitter cover.
7LJKWHQLQJWRUTXHF1P
$OZD\VNHHSWKHFRYHURQWKHWUDQVPLWWHUZKLOHZRUNLQJWRSUHYHQWDQ\HIIHFWIURPGXVW
,QVWDOOWKHFRYHUILUPO\WRHQVXUHZDWHUUHVLVWDQWSHUIRUPDQFH
. Check the LED display.
The transmitter starts when the
batteries are installed. The LEDs of the
transmitters light as follows depending
on the actual sensor mode.
• When it is in pedaling monitor
mode:
The LEDs
light
green for 10
seconds
• When it is in dual power meter
mode:
The LEDs
light
orange for 10
seconds
• When it is in single power meter
mode:
The LEDs
blink
orange for 10
seconds
Push switch
LED
Water-proof
packing
• If the LEDs do not light for more than 5 seconds after installing the batteries, remove the batteries once, and after more than 1 minute, install them
again. If the LEDs still do not light, the battery may be almost empty. Replace the battery with a new one. Dispose of useless batteries as instructed by
the local government.
While tightening the screws, do not
use excessive force or over-tighten
them. The plastic cover can crack if
\RXGRVR
Use a tool that can measure
the torque to tighten the screws.
%HFDUHIXOQRWWRGURSRUORVHWKHEDWWHU\ZKHQLQVWDOOLQJLW
'RQRWXVHEDWWHULHVRWKHUWKDQ&5
,QVWDOOWKHFRYHUILUPO\WRHQVXUHZDWHUUHVLVWDQWSHUIRUPDQFH
,IWKH/('VGRQRWOLJKWIRUPRUHWKDQVHFRQGVDIWHULQVWDOOLQJWKHEDWWHULHVUHPRYHWKHEDWWHULHVRQFHDQGDIWHUPRUHWKDQPLQXWH
LQVWDOOWKHPDJDLQ,IWKH/('VVWLOOGRQRWOLJKWWKHEDWWHU\PD\EHDOPRVWHPSW\5HSODFHWKHEDWWHU\ZLWKDQHZRQH
,IWKH/('VOLJKWUHGUHIHUWR7URXEOHVKRRWLQJSDJH
5
Install the batteries
5LJKWWUDQVPLWWHU,QVWDOOWKHRZHYHUGRQRWLQVWDOOWKHEDWWHU\FRYHUDWWKHPRPHQWVR\RXFDQFKHFNWKH/('
/HIWWUDQVPLWWHU$IWHULQVWDOOLQJWKHEDWWHU\SODFHWKHFRYHUZLWKWKHWULDQJXODUDUURZSRLQWLQJWR>23(1@DQGWXUQLWZLWK
FRLQWR>&/26(@
Left side
Right side
