<ENGLISH>
Connecting the Units
Hide-away TV Tuner
(e.g. GEX-P7000TV)
(sold separately)
IP-BUS cable
(supplied with the TV tuner)
Blue
Black
Red
Green
20 pin cable
(supplied with the display)
FM MODULATOR
IP-BUS MAIN UNIT
IP-BUS AV MASTER
STAND ALONE
IP-BUS
Head Unit
(sold separately)
This product
Blue
IP-BUS cable
(sold separately)
15 cm
40 cm
AV-BUS cable
(sold separately)
Red
Blue
AV system display
(e.g. AVX-7300)
(sold separately)
Not used.
When Connecting the Head Unit
Fig. 3
This product features a built-in
remote sensor. If it is installed in a
location where reception of the
remote control signal is not
possible, use a separately sold
remote sensor.
STAND ALONE
IP-BUS
This product
Remote sensor
(sold separately)
Display with RCA
input jacks
RCA cable (supplied)
To audio inputs
To video input
RCA cable (sold separately)
Yellow (front
video output)
White (audio output (Left))
Red (audio output (Right))
When Connecting the Display with RCA Input Jacks
Fig. 4
Fig. 5
When Using a Display Connected Rear Video Output
This product’s rear video output is for connection of a display to enable passengers in the
rear seats to watch the DVD or Video CD.
WARNING
• NEVER install the display in a location that enables the Driver to watch the DVD or
Video CD while Driving.
STAND ALONE
IP-BUS
This product
Display with RCA
input jacks
RCA cable (supplied)
To audio inputs
To video input
RCA cable (sold separately)
Yellow (rear
video output)
White (audio output (Left))
Red (audio output (Right))
Light green
Used to detect the ON/OFF status of the parking brake.
This lead must be connected to the power supply side
of the parking brake switch.
Parking brake switch
Red
To electric terminal controlled by ignition
switch (12 V DC) ON/OFF.
Fuse resistor
Fuse holder
Black (ground)
To vehicle (metal) body.
Power supply side
Ground side
Connection method
2. Clamp firmly with
needle-nosed pliers.
Clamp the parking brake
switch power supply side
lead.
Note:
• The position of the parking brake switch depends
on the vehicle model. For details, consult the
vehicle Owner’s Manual or dealer.
This Product
1.
Yellow
To terminal always supplied with power
regardless of ignition switch position.
Connecting the Power Cord
This product comes with two kinds of power cord. Use the short cord when installing this
product in the dashboard, and the long cord when installing it on the floor.
Note:
• Use commercially available installation parts to install this product on the floor.
Fig. 6
Connecting a rear display
Instead of video output for viewing on a front display, you can connect for video output
enabling viewing on a rear display (for passengers in the rear of the car). If you decide to
use a rear display, be sure to follow the warnings on the next page.
