3
S-IC871A
5
7
8
5
7
8
C
D
F
A
B
E
1.2 REATTACHMENT TO THE CEILING 1.3 REPLACEMENT OF PARTS
Reattach the safety belt as it originally was attached.
Connect the speaker cables to the speaker.
At this stage, check that sound is properly output.
With the fixation claws fallen inwards, insert the speaker
into the ceiling, then lightly tighten the 4 screws for
fixation claws.
Lightly pull down the speaker to ensure that the 4 fixation
claws have been raised outwards to secure the speaker
to the ceiling.
Tighten the 4 screws.
If a new grill is to be attached, attach 8 pieces of butyl
tape, as shown in the figure below, then remove the
paper liner.
The Network Assy is attached to the frame from the rear
of the speaker with 4 screws.
To remove it, first disconnect the speaker cables from it
then remove the screws.
The Speaker Unit is attached with 4 screws.
To remove it, first remove the Network Assy then remove
the 4 screws.
When reattaching, place the Speaker Unit as shown in
the photo then attach it.
Be sure to reconnect the cables as they were originally
connected, paying attention to the combination of
colors of the cables and the input terminals.
After connection, lightly pull the cables to ensure that
they are securely connected.
Make sure that the wires of a cable do not protrude
from the terminal and come into contact with other
wires.
Adjust the speaker position so that the Pioneer logo is
located as it originally was.
When using an electric screwdriver, gradually increase
the torque setting from the minimum value until a
value with which a screw starts rotating is reached,
then tighten the screw.
Tolerable maximum torque: 1.0 N·m
Make sure that no screw is loose and that there is no
gap between the ceiling and the frame.
Butyl tape
Mark
Cutout
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299