Additional information
12
92
En
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie
in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest
Pioneer authorized service center or your dealer to carry out repair work.
• If the system does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
General
Problem
Remedy
The power does not turn on. • Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the
rear panel. This could cause the system to shut off automatically.
No sound is output when a
function is selected.
• If you’re using the line input, make sure the component is
connected correctly (see
Connecting auxiliary components
on
page 90).
• Press
MUTE
on the remote control to turn muting off.
• Adjust the
VOLUME
.
No image is output when
playing discs.
• Make sure the TV is connected correctly (see
Connecting to your TV
on page 20).
• Reset the video output to interlace (see
About progressive scan video
on page 77).
No sound from surround or
center speakers.
• Refer to
Setting the channel levels
on page 72 to check the speaker
levels.
• Check that you haven’t selected the
STEREO
sound mode (see
Listening in stereo
on page 46).
• Check that the Virtual mode is not on (see
Using the Advanced
Surround effects
on page 47).
• Connect the speakers properly (see page 13, 16).
Can’t operate the remote
control.
• Replace the batteries (see
Putting the batteries in the remote control
on page 9).
• Operate within 23 ft. / 7 m, 30° of the remote sensor on the front
panel (see
Using the remote control
on page 10).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
XV-HDT530.book 92 ページ ２００３年５月１０日 土曜日 午後４時６分
