Additional information
12
95
En
Wireless Speaker System
Sound is mono only.
• Check that the tuner is not set to FM mono (see
Improving poor FM
reception
on page 42).
Considerable noise in radio
broadcasts.
• Tune into the correct frequency.
• Connect the antenna (see
Connecting the supplied antennas
on
page 22 and
Connecting external antennas
on page 89).
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall.
• Connect an outdoor FM antenna (see
Connecting external antennas
on page 89).
• Adjust the direction and position for best reception.
• Connect an additional internal or external AM antenna (see
AM loop
antenna
on page 22 and
Connecting external antennas
on page 89).
• Turn off any other equipment that may be causing the noise or move
it away from the system unit.
• The tuning interval is incorrect for your country or region. Try
switching the tuning interval (frequency step) (see
Changing the
frequency step
on page 85).
Problem
Remedy
Problem
Remedy
Audio is interrupted.
•This system uses high frequency radio waves that have properties
similar to light, such as linearity, reflection, refraction, diffraction,
and interference. Therefore, placement of the system can result in
weak radio waves and/or interruption.
•The distance between the transmitter and receiver may be too large.
Use the receiver within the reach of radio wave from the transmitter.
•Is the system being used in a location with favorable condition for
electrical noise generation?
Audio is suddenly
interrupted.
•There may be radio communication equipment using the same
frequency band (2.4 GHz) as this system, such as a Bluetooth device,
radio LAN device or microwave oven, operating nearby.
Power shuts off when the
switch is on or the
system is in operation.
•It is likely that the system is out of order. Ask your nearest PIONEER
authorized service center or your dealer to carry out repair work.
XV-HDT530.book 95 ページ ２００３年５月１０日 土曜日 午後４時６分
