Connecting up
02
7
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 2
Connecting up
Making cable connections
Make sure not to bend the cables over the top
of this unit. This may cause a humming noise
from the speakers.
Important
• Before making or changing any
connections, switch off the power and
unplug the power cord from the AC outlet.
Connecting the speakers
Place the front left and right speakers at equal
distances from the TV, then connect them as
shown below.
1
Caution
•
Do not connect this speaker to any amplifier
other than the one supplied with this
system. Connection to any other amplifier
may result in a malfunction or fire.
• Make sure that the bare speaker wires
cannot touch each other, or come into
contact with other metal parts once the
unit is switched on.
• Do not attach these speakers to the wall or
ceiling. They could fall and cause injury.
1
Twist and pull off the protective shields
on each wire.
2
Connect to the speaker terminals on the
rear of the unit.
Make sure to insert the striped wire into the red
(+) tab and the white wire into the black (–) tab.
Note
1 These speakers are magnetically shielded. However, depending on the installation location, color distortion may occur if the
speaker system is installed extremely close to the screen of a television set. If this happens, turn off the television set, and then
turn it on after 15 to 30 minutes. If the problem persists, move the speaker system away from the television set.
Left
speaker
Listening
position
Right
speaker
XV-HL7DV_02_connect_up.fm 7 ページ ２００５年３月３０日 水曜日 午前１１時５４分
