- 7 -
floor
floor
16"
Wall structure
Wood studs behind
the wall structure
Stud centers
marking
Tilt back plate
Adjusting the
mount
Desired height
marking
Installing the mounts
CENTER
OF
VIEWING
HEIGHT
Step 3
CAUTION: The plasma displays are fragile and heavy. At least two (2) qualified personnel are strongly recommended for the installation of this product.
Please verify that your plasma mounting points from the back of the chassis are centered before installing the back plate if not take proper measurements for your installation
requirements. Select the area where the plasma will be installed and make sure it can support the weight standards (see warning on page 3). Locate the 16" wood stud centers behind
the wall using a (commercially available) stud finder and mark the center of the studs when found. Set the mounting bracket to the wall and mark the desired height by marking the wall
mount. See fig 3.
