Pioneer Premier DEH-P640, Operation Manual

Page: 31 / 84

06
Section
Audio Adjustments
En 31
English
Español
Deutsch
F
rançais
Italiano
Nederlands
Adjusting subwoofer settings
When the subwoofer output is on, you can
adjust the cut-off frequency and the output level
of the subwoofer.
1 Press
AUDIO
to select the
Sub-W2
.
When the subwoofer output is on, you can
select the
Sub-W2
. Press
AUDIO
until
Sub-W2 80
(Hz) appears in the display.
• If the subwoofer setting has been previously
adjusted, the frequency of that previously
selected will be displayed, such as
50
(Hz) or
125
(Hz).
2 Press
2
or
3
to select cut-off frequency.
Press
2
and
50
(Hz) is displayed. Press
3
and
125
(Hz) is displayed. Only frequencies lower
than those in the selected range are output
from the subwoofer.
3 Press
5
or
∞
to adjust the output level of
the subwoofer.
Each press of
5
or
∞
increases or decreases
the level of the subwoofer (e.g.,
+6
to
–6
).
Press
5
or
∞
until you see the desired value
displayed.
Using non fading output
When the non fading output setting is on, the
audio signal does not pass through this unit’s
low pass filter (for the subwoofer), but is output
through the RCA output.
1 Press
AUDIO
to select non fading output
on/off mode.
When the subwoofer controller setting is
S.W
Control:EXT
, you can select non fading output
on/off mode. Press
AUDIO
until
NonFad ON
appears in the display.
2 Press
5
to turn non fading output on.
NonFad ON
appears in the display. non fading
output is now on.
• You can turn off non fading output by pressing
∞
.
Adjusting non fading output level
When the non fading output is on, you can
adjust the level of non fading output.
1 Press
AUDIO
to select non fading output
setting mode.
Press
AUDIO
until
NonFad 0
appears in the dis-
play.
2 Press
5
or
∞
to adjust the output level of
the non fading.
Each press of
5
or
∞
increases or decreases
the level of the non fading (e.g.,
+6
to
–6
).
Press
5
or
∞
until you see the desired value
displayed.