<CRD3539-A>35
08
Section
Initial Settings
En
35
English
Español
Deutsch
F
rançais
Italiano
Nederlands
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press
FUNCTION
to select
AUX
.
Press
FUNCTION
repeatedly until
AUX
appears
in the display.
2 Select
AUX
on or off with
5
/
∞
.
Pressing
5
/
∞
will switch
AUX
between on and
off and that status will be displayed (e.g.,
AUX :ON
).
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car’s headlights are turned on. You
can switch dimmer on or off.
1 Press
FUNCTION
to select
DIMMER
.
Press
FUNCTION
repeatedly until
DIMMER
appears in the display.
2 Select
DIMMER
on or off with
5
/
∞
.
Pressing
5
/
∞
will switch
DIMMER
between on
and off and that status will be displayed (e.g.,
DIMMER :ON
).
Selecting the illumination color
This product is equipped with two illumination
colors, green and red.
You can select the desired illumination color.
1 Press
FUNCTION
to select
ILL. CLR
.
2 Select the desired illumination color with
2
/
3
.
Pressing
2
/
3
will switch
ILL. CLR
between red
or green and that status will be displayed (e.g.,
ILL. CLR :GRN
).
Switching the rear output setting
This unit’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker or subwoofer connection. If you
switch the rear output setting to the subwoofer,
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
• If you connect a subwoofer to the rear output,
set the output setting to subwoofer.
• Even if you change this setting, there is no
output unless you switch the subwoofer output
on (refer to
Using subwoofer output
on page 32).
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this set-
ting.
1 Press
FUNCTION
to select the rear output
setting mode.
Press
FUNCTION
repeatedly until
FRT+REAR
appears in the display.
• If the rear output setting has been set to the
subwoofer then
FRT+S/W
will be displayed.
2 Select full-range speaker or subwoofer
with
2
/
3
.
Pressing
2
/
3
will switch between
FRT+REAR
(full-range speaker) and
FRT+S/W
(subwoofer)
and that status will be displayed.
CRD3539A_Eng 9/21/01 4:44 PM Page 35
