Setting the clock
Use these instructions to set the clock.
1 Press SOURCE and hold until the unit
turns off.
2 Press and hold AUDIO until clock ap-
pears in the display.
3 Press
c
or
d
to select the segment of
the clock display you wish to set.
Pressing
c
or
d
will select one segment of the
clock display:
Hour
Minute
As you select segments of the clock display
the segment selected will blink.
4 Press VOLUME up/+ or down/
to set
the clock.
Pressing
VOLUME
up/+ will increase the se-
lected hour or minute. Pressing
VOLUME
down/
will decrease the selected hour or min-
ute.
#
To cancel clock settings, press
BAND
.
#
You can also cancel clock settings by holding
down
AUDIO
until the unit turns off.
Turning the clock display
on or off
You can turn the clock display on or off.
%
Press and hold CLOCK to turn the clock
display on or off.
Each press and hold of
CLOCK
turns the clock
display on or off.
#
The clock display disappears temporarily
when you perform other operations, but the clock
display appears again after 25 seconds.
Introduction of XM operation
You can use this unit with a separately sold uni-
versal XM satellite digital tuner system (GEX-
FM913XM) or XM satellite digital tuner (GEX-
P910XM).
For details concerning operation, refer to the
XMtuner
s operation manuals. This section
provides information on XMoperations with
this unit which differs from that described in
the XMtuner
s operation manual.
!
This unit controls XMtuner as an external
unit.
XM operation
XMoperation of the following function with
this unit differs.
!
Swiching the XM channel select setting
(Refer to this page.)
Swiching the XM channel select
setting
You can switch if you select a channel with a
channel number or from a channel category
when you select a channel.
1 Press LOCAL/BSM to select channel se-
lect setting.
2 Each press of LOCAL/BSM changes the
channel select mode in the following
order:
Channel number select mode
Channel cate-
gory select mode
Other Functions
En
17
English
Section
08
HHHHHHHHHHHHHH
