English
Français
Italiano
Español
Nederlands
Deutsch
3
En
Connecting the speakers
Connecting the speakers
Connecting a TV and playback component
Plugging the receiver
CAUTION
• These speaker terminals carry HAZARDOUS LIVE voltage. To prevent
the risk of electric shock when connecting or disconnecting the
speaker cables, disconnect the power cord before touching any
uninsulated parts.
• Make sure that all the bare speaker wire is twisted together and
inserted fully into the speaker terminal. If any of the bare speaker
wire touches the back panel it may cause the power to cut off as a
safety measure.
• Do not connect the supplied subwoofer to any amplifier other than
the one supplied with this system. Connection to any other amplifier
may result in malfunction or fire.
Make sure you connect the speaker on the right to the right (R) terminal and the speaker on the left to the left (L) terminal. Also make sure the positive and negative (+/–)
terminals on the receiver match those on the speakers.
Bare wire connections
1
Push open the tabs and insert exposed wire.
2
Release the tabs.
Placing the speakers
The receiver will work with just two stereo speakers (the
front speakers in the diagram) but using at least three
speakers is recommended, and a complete setup is
best for surround sound.
To achieve the best possible surround sound, install
your speakers as shown below.
5.1 channel surorund system:
R
SL
L
SW
C
SR
• In addition, surround back speakers can also be
connected.
l
“Connect the surround back speakers”
• The subwoofer and surround speakers are not
magnetically shielded and so should not be placed
near a TV or monitor, as the interaction of magnetic
materials can cause distortion of the colors on your
TV screen. Devices easily affected by magnetism
(magnetic media cards, wrist-watches, video tapes,
etc.) should not be placed near the subwoofer and
surround speakers.
• The front speakers and center speaker furnished
in this system are designed for use close to a CRT-
based TV or color monitor. However, if color distortion
is caused due to the installation, try turning off the
power to the CRT-based TV or color monitor for 15
to 30 minutes, then turning on the power again. The
self-degaussing function built into the CRT-based TV
or color monitor should help ameliorate the effect
of the speakers on the image. If color distortion
continues to be a problem, separate the speakers
farther away from the screen. If magnets or devices
emitting magnetic fields are installed nearby, the
interactive effect with the speaker system may cause
color distortion in a CRT-based TV or color monitor.
• Do not attach center speaker and subwoofer to the
wall or ceiling, as they may cause injury in the event
of a fall.
1
2
Flow of settings on the receiver
VENTILATION CAUTION
When installing this unit, make sure to leave space around the unit for
ventilation to improve heat radiation (at least 20 cm at top, 10 cm at rear,
and 10 cm at each side).
WARNING
Slots and openings in the cabinet are provided for ventilation to ensure
reliable operation of the product, and to protect it from overheating. To
prevent fire hazard, the openings should never be blocked or covered
with items (such as newspapers, table-cloths, curtains) or by operating
the equipment on thick carpet or a bed.
D3-4-2-1-7b*_A1_En
L
R
R
L
COAXIAL
AUDIO
SPEAKERS
ANTENNA
OPTICAL
ASSIGNABLE
OUT
A
CD-R/TAPE
OUT
SURR BACK
PRE OUT
L
R
(Single)
(
CD-R / TAPE
)
IN
CD/SAT
IN
TV
IN
IN
DVD
BD IN
CD/SAT
(
TV
)
IN
1
IN
1
FM
UNBAL
75
AM LOOP
FRONT
CENTER
SURROUND
SUBWOOFER
R
L
R
L
AC IN
Front Right
Center
Front Left
Subwoofer
Surround
Right
Surround
Left
Be sure to complete
all connections before
connecting this unit to
the AC power source.
The unit is a full-fledged AV receiver equipped with an
abundance of functions and terminals. It can be used
easily after following the procedure below to make the
connections and settings.
L
Front left
(S-11-P)
SW
Subwoofer
(S-22W-P)
C
Center
(S-11-P)
This receiver
(VSX-321-K-P)
Blu-ray Disc
player
TV
R
Front right
(S-11-P)
SL
Surround left
(S-11-P)
SR
Surround right
(S-11-P)
CAUTION
• Install the center speaker below the TV so that the
sound of the center channel is localized at the TV
screen.
• When installing the center speaker on top of
the TV, be sure to secure it with tape or some
other suitable means. Otherwise, the speaker
may fall from the TV due to external shocks such
as earthquakes, endangering those nearby or
damaging the speaker.
