What
’
s what
Front side
Rear side
To adjust the switch, use a flathead screwdri-
ver if needed.
1
Power indicator
The power indicator lights up to indicate
power ON.
2
BFC (beat frequency control) switch
Located front side the unit. If beats are audi-
ble while listening to MW/LW broadcasts via
car stereo, change the
BFC
switch using a
small flathead screwdriver.
3
GAIN (gain) control
Adjusting gain controls
CHANNEL A
(chan-
nel A) and
CHANNEL B
(channel B) helps
align the car stereo output to the Pioneer
amplifier. Default setting is the
NORMAL
position.
If output remains low, even when the car
stereo volume is turned up, turn controls to
lower level. If distortion occurs when the car
stereo volume is turned up, turn these con-
trols to higher level.
!
If using only one input plug, set the gain
controls for speaker outputs A and B to
the same position.
!
For use with an RCA equipped car stereo
(standard output of 500 mV), set to the
NORMAL
position. For use with an RCA
equipped Pioneer car stereo, with max.
output of 4 V or more, adjust level to
match that of the car stereo output.
4
LPF (low-pass filter)/HPF (high-pass fil-
ter) select switch
Switch the settings based on the connected
speaker.
!
When the Subwoofer is connected:
Select
LPF
. This eliminates high range
frequency and outputs low range fre-
quency.
!
When the full range speaker is con-
nected:
Select
HPF
or
OFF
.
HPF
eliminates low
range frequency and output high range
frequency.
OFF
outputs the entire fre-
quency range.
5
INPUT SELECT (input select) switch
Select
2CH
for two-channel input and
4CH
for four
–
channel input.
Setting gain properly
!
Protective function included to prevent
malfunction of the unit and/or speakers
due to excessive output, improper use or
improper connection.
!
When outputting high volume sound etc.,
this function cuts off the output for a few
seconds as a normal function, but output
is restored when the volume of the head
unit is turned down.
Setting the Unit
En
5
English
Section
02
