En
Ä SS@BGÄSGDÄSNOÄO@MDKÄBNUDQÄ@MCÄ!@CFD
Use the removed screws to attach the top
panel cover (fastening torque 0.6 to 0.8
N·m).
Remove the release paper and affix the
Badge in the orientation shown in the
following illustration.
1
2
3
1
Screws
2
Badge
3
Top panel cover
Additional information
2ODBHÆB@SHNMR
Power source ...................... 14.4 V DC (10.8 V to 15.1 V
allowable)
Grounding system .............. Negative type
Current consumption ......... 41 A (at continuous power,
4
:
Normal mode)
56 A (at continuous power,
4
:
High power mode)
Average current consumption
.......................................... 9.3 A (4
:
for six channels,
Normal mode)
12.5 A (4
:
for six channels,
High power mode)
14.5 A (2
:
for six channels,
Normal mode)
16.7 A (2
:
for six channels,
High power mode)
Fuse ..................................... 40 A × 2
Dimensions (W × H × D) .. 260 mm × 50.6 mm × 180 mm
(10-1/4 in. × 2 in. × 7-1/8 in.)
Weight ................................. 2.6 kg (5.7 lbs)
(Leads for wiring not
included)
Continuous power output .. 75 W × 6 (at 14.4 V, 4
:
,
+]WRN+]7+'
Normal mode)
100 W × 6 (at 14.4 V, 2
:
,
N+]7+'1RUPDO
mode)
150 W × 3 (at 14.4 V, 4
:
,
0212N+]7+'
Install tapping screws in such a way that the
screw tip does not touch any wire. This is
important to prevent wires from being cut by
vibration of the boat, which can result in fire.
Make sure that wires do not get caught in
the sliding mechanism or touch the legs of a
person in the boat as short-circuit may result.
CAUTION
Place all cables away from hot places, such
as near the heater outlet.
The optimal installation location differs
depending on the boat model. Secure the
amplifier at a sufficiently rigid location.
Check all connections and systems before
final installation.
Example of installation on
the chassis
Ä Ä/K@BDÄSGDÄ@LOKH×DQÄHMÄSGDÄCDRHQDCÄ
installation location.
Insert the supplied tapping screws (4 mm
× 25 mm) into the screw holes and push
on the screws with a screwdriver so they
make an imprint where the installation
holes are to be located.
Ä Ä#QHKKÄÄLLÄÄHMÄCH@LDSDQÄGNKDRÄHMÄ
the chassis.
Ä Ä(MRS@KKÄSGDÄ@LOKH×DQÄVHSGÄSGDÄTRDÄNEÄ
RTOOKHDCÄS@OOHMFÄRBQDVRÄÄLLÄÐÄÄ
LL
1
5
3
4
2
1
Tapping-screws (4 mm × 25 mm)
2
Installation surface
3
Hole-to-hole distance: 228.3 mm (9 in.)
4
Hole-to-hole distance: 160.8 mm (6-11/32 in.)
5
Hole-to-hole distance: 226 mm (8-29/32 in.)
