19
> Install
> Setup
> Playback
E
N
■
Network
0
When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the setting
automatically. To assign fixed IP addresses to each component, you must set "DHCP" to
"Disable" and assign an address to this unit in "IP Address" as well as set information
related to your LAN, such as Subnet Mask and Gateway.
0
Wait for a while if "Network" cannot be selected. It will appear when the network feature is
started.
Wi-Fi
Connect the unit to network via wireless LAN router.
"On": Wireless LAN connection
"Off(Wired) (Default Value)": Wired LAN connection
Wi-Fi Setup
You can configure wireless LAN settings by pressing ENTER
when "Start" is displayed.
Wi-Fi Status
The information of the connected access point will be displayed.
"SSID": SSID of the connected access point.
"Signal": Signal strength of the connected access point.
"Status": Status of the connected access point.
MAC Address
This is the MAC address of this unit.
This value is specific to the component and cannot be changed.
DHCP
"Enable (Default Value)": Auto configuration by DHCP
"Disable": Manual configuration without DHCP
If selecting "Disable", you must set "IP Address", "Subnet Mask",
"Gateway", and "DNS Server" manually.
IP Address
Displays/Sets the IP address.
Subnet Mask
Displays/Sets the subnet mask.
Gateway
Displays/Sets the gateway.
DNS Server
Displays/Sets the primary DNS server.
Proxy URL
Displays/Sets the proxy server URL.
Proxy Port
Displays/Sets the proxy server port number when you enter
"Proxy URL".
Friendly Name
Change the device name for this unit which is shown on other
devices connected to the network to an easily recognized name.
This is set to Pioneer AC-400
＊＊＊＊＊＊
at the time of
purchase. ("
＊
" stand for alphanumeric characters identifying
each unit)
1. Press ENTER to display the Edit screen.
2. Select a character or symbol with the cursors and press
ENTER.
Repeat it to input 31 or less characters.
"A/a": Switches between upper and lower cases. (Pressing
MODE on the remote controller also toggles between upper
and lower cases.)
"
←
" "
→
": Moves the cursor to the arrow direction.
"
": Removes a character on the left of the cursor.
"
": Enters a space.
0
Pressing CLEAR on the remote controller will remove all the
input characters.
3. After inputting, select "OK" with the cursors and press
ENTER.
The input name will be saved.
Usage Data
As a means of improving the quality of our products and
services, our company may collect information about your usage
over the network. Select "Yes" if you agree to our collecting this
information. Select "No" if you do not want us to collect this
information. (Default Value is No)
You can set this after confirming the Privacy Policy. When you
select "Usage Data" and press ENTER, the Privacy Policy is
displayed. (The same screen is displayed once also when
setting up the network connection.) If you agree to the collection
of the information, this setting also becomes "Yes". Note that if
you agree to the Privacy Policy but select "No" for this setting,
the information will not be collected.
Network Check
You can check the network connection.
Press ENTER when "Start" is displayed.
