Pioneer FH-X700BT, Installation Manual

Page: 2 / 32

Important
!
Check all connections and systems before
final installation.
!
Do not use unauthorized parts as this may
cause malfunctions.
!
Consult your dealer if installation requires
drilling of holes or other modifications to the
vehicle.
!
Do not install this unit where:
—
it may interfere with operation of the vehicle.
—
it may cause injury to a passenger as a result
of a sudden stop.
!
The semiconductor laser will be damaged if
it overheats. Install this unit away from hot
places such as near the heater outlet.
!
Optimum performance is obtained when the
unit is installed at an angle of less than 60°.
60°
!
When installing, to ensure proper heat dis-
persal when using this unit, make sure you
leave ample space behind the rear panel and
wrap any loose cables so they are not block-
ing the vents.
5cm cm
Leave ample
space
5 cm
5 cm
!
Use commercially available parts when in-
stalling.
How to install
This unit can be installed properly using either
of the methods in the below list.
!
Installation with the holder
!
Installation using the screw holes on the side
of the unit
Before installing this unit
1 Remove the trim ring.
1
1
Trim ring
2 Insert the supplied extraction keys into
both sides of the unit until they click into
place.
3 Pull the unit out of the holder.
Remove the holder.
1
1
Holder
(factory-supplied part)
Installation with the holder
1 Install the holder into the dashboard.
After inserting the holder into the dashboard, se-
lect and bend the tabs appropriate to the thick-
ness of the dashboard material. (Install this unit
as firmly as possible using the top and bottom
tabs. To secure this unit, bend the tabs 90 de-
grees.)
1
2
1
Dashboard
2
Holder
(factory-supplied part)
2 Install this unit.
1
1
Dashboard
3 Attach the trim ring.
1
1
Trim ring
Removing the holder
The procedure is the same as that for Before in-
stalling this unit. For details, refer to
Before in-
stalling this unit
on this page.
Installation
2
Section
Installation
En
01