Pioneer Elite VSX-50, Service Manual

Page: 105 / 105

VSX-50
105
5 6 7 8
5 6
7
8
C
D
F
A
B
E
Resetting the system
Use this feature to reset the system to its factory default
settings.
1 Press RECEIVER to switch the receiver into
standby.
2 Press MCACC SETUP and RECEIVER SETUP at the
same time.
The display prompts you to confirm.
3 Within 5 seconds, press (cursor down).
The display shows OK? .
4 Within 5 seconds, press (cursor up).
The display shows OK and the receiver should now be
reset.
Note
• If the receiver is disconnected from the power outlet
for more than a month it will reset to the default
settings.
• The above reset doesn’t affect the presets that you
have programmed into the remote control (see Using
the remote control with other components).
Default receiver settings
The table below shows the factory default settings. When
you reset the system, the receiver reverts to these
defaults:
Note
• The default settings for the remote control to control
other components can be found in Using the remote
control with other components.
RECEIVER
MCACC
SETUP RECEIVER
SETUP
Setting type Default setting
Input DVD
Master volume – – – dB (no sound)
Listening mode AUTO (all inputs)
Listening mode (w/
headphones) STEREO (all inputs)
Sound mode OFF
Dialog OFF
Surround Back
Channel mode ON (when speaker is
connected)
Input signal select AUTO
Speakers (front,
center, surround,
surround back) setting Automatically sensed
Subwoofer setting 200 Hz
LFE Attenuator 0 dB
Speaker distance
settings Front left/right: 10 ft.
Center: 10 ft.
Surround left/right: 10 ft.
Surround Back: 10 ft.
Subwoofer: 10 ft.
Dynamic Range
Control OFF
Dual Mono ch1
Input Attenuator OFF (all inputs)
DVD(TV/SAT) COAX
jack assignment
DVD
TV/SAT(DVD) OPT1
jack assignment
TV/SAT
Channel levels Front: 0 dB
Center: 0 dB
Surround: 0 dB
Surround Back: 0 dB
Subwoofer: 0 dB
SR+ mode OFF