Names and functions of parts
10
Rear
DIGITAL IN OPTICAL/COAXIAL terminals:
Connected to players. Use a digital optical cable or
digital coaxial cable for connection with the digital
audio output jack of a player.
FM UNBAL 75
h
and AM LOOP ANTENNA
terminals:
The supplied antennas are connected.
LAN (10/100) port:
Connect to the router with an
Ethernet cable.
IR IN A/B, IR OUT jacks:
Connected to the multi-room
remote control kit. (*)
12V TRIGGER OUT A/B/C jacks:
Allows you to
connect a device with trigger input jack to enable
power link operation between the device and the unit.
(*)
*
Special devices or cable connections are necessary to use the
control functions
and
. Contact the specialized stores for
more information.
Wireless antenna:
Used for Wi-Fi connection or when
using a
Bluetooth
enabled device. Adjust their angles
according to the connection status.
AC IN terminal:
The supplied power cord is
connected. Always connect the power cord to an AC
outlet only after connecting it to the AC IN terminal of
the unit. Disconnect the power cord only after putting
the unit into standby mode. To avoid electrical shock,
always disconnect the power cord from the AC outlet
before disconnecting the other end.
*
Turning on the unit may cause a momentary power surge that
might interfere with other electrical equipment on the same
circuit. If this is a problem, plug the unit into a different branch
circuit.
SIGNAL GND terminal:
Connect if the record player
has a ground wire.
LINE IN terminals:
Connected to players. Use an
RCA cable for connection with the LINE OUT terminal
of a player.
LINE OUT terminals:
Use when connecting recording
devices, such as a cassette tape deck. Use an RCA
cable to connect to the LINE IN terminal on a recording
device.
PRE OUT jacks:
Connect a power amplifier.
SUBWOOFER jack:
Connect a subwoofer with built-in
amplifier to amplify bass output.
ZONE 2 PRE OUT L/R/SUBWOOFER terminals:
Audio output jack connected to a pre-main amplifier, a
power amplifier or a subwoofer with built-in amplifier
for multi-zone playback in a separate room.
SPEAKERS A/B terminals:
You can connect a set of
left and right speakers to each of the A/B terminals.
90°
90°
180°
90°
180°
90°
SX-N30MDC_mst.book 10 ページ ２０１５年１１月２日 月曜日 午後１時２４分
