Additional information
07
21
En
Chapter 7:
Additional information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
Problem
Remedy
The power does not turn on.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the rear
panel. This could cause the receiver to shut off automatically.
• If you’re trying to switch on using the remote control, make sure the
front panel
POWER
button is switched on first.
• If the power shuts off automatically, take the unit to your nearest
Pioneer authorized service center or your dealer for servicing.
No sound is output when a
function is selected.
• Make sure the component is connected correctly (refer to
Connecting
up
on page 8).
• Press
MUTE
on the remote control to turn muting off.
Considerable noise in radio
broadcasts.
• Connect the antenna (page 9) and adjust the position for best reception.
• Route any loose cables away from the antenna terminals and wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall (or connect an outdoor FM antenna).
• Connect an additional internal or external AM antenna (page 9).
• Turn off equipment causing interference or move it away from the
receiver (or move antennas farther away from equipment causing noise).
Broadcast stations cannot be
selected automatically.
• Connect an outdoor antenna (refer to page 9).
Noise during playback of a
cassette deck.
• Move the cassette deck further from your receiver, until the noise
disappears.
Can’t operate the remote
control.
• Replace the battery (refer to page 7).
• Operate within 7 m (23 ft.), 30° of the remote sensor on the front panel
(refer to page 12).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
A6_KU.book 21 ページ ２００６年１１月１３日 月曜日 午後３時１分
