Pioneer DXT-1469UB, Owner'S Manual

Page: 8 / 72

This unit
3 4 5
2 1
1
Power cord input
2
Rear output
3 Antenna input
4
Fuse (10 A)
5
Wired remote input
Hard-wired remote control adaptor can be
connected (sold separately).
Power cord








1
8
9
c
d
6
3 2
4
5
7
a
b
e
f
h
g
L R
F
R
1
To power cord input
2
Left
3 Right
4 Front speaker
5
Rear speaker
6
White
7
White/black
8 Gray
9 Gray/black
a
Green
b
Green/black
c
Violet
d
Violet/black
e Black (chassis ground)
Connect to a clean, paint-free metal location.
f
Yellow
Connect to the constant 12 V supply termi-
nal.
g
Red
Connect to terminal controlled by ignition
switch (12 V DC).
h
Blue/white
Connect to system control terminal of the
power amp or auto-antenna relay control ter-
minal (max. 300 mA 12 V DC).
Note
With a 2 speaker system, do not connect any-
thing to the speaker leads that are not con-
nected to speakers.
Power amp (sold separately)
Perform these connections when using the op-
tional amplifier.




1
3
2
4
5 5
1
System remote control
Connect to Blue/white cable.
2 Power amp (sold separately)
3
Connect with RCA cables (sold separately)
4
To Rear output
5
Rear speaker
Installation
Important
!
Check all connections and systems before
final installation.
!
Do not use unauthorized parts as this may
cause malfunctions.
!
Consult your dealer if installation requires
drilling of holes or other modifications to the
vehicle.
!
Do not install this unit where:
—
it may interfere with operation of the vehicle.
—
it may cause injury to a passenger as a result
of a sudden stop.
!
The semiconductor laser will be damaged if
it overheats. Install this unit away from hot
places such as near the heater outlet.
!
Optimum performance is obtained when the
unit is installed at an angle of less than 60°.
60°
!
When installing, to ensure proper heat dis-
persal when using this unit, make sure you
leave ample space behind the rear panel and
wrap any loose cables so they are not block-
ing the vents.
5cm cm
Leave ample
space
5 cm
5 cm
DIN front/rear mount
This unit can be properly installed using either
front-mount or rear-mount installation.
Use commercially available parts when instal-
ling.
DIN Front-mount
1 Insert the mounting sleeve into the dash-
board.
For installation in shallow spaces, use the sup-
plied mounting sleeve. If there is enough space,
use the mounting sleeve that came with the ve-
hicle.
2 Secure the mounting sleeve by using a
screwdriver to bend the metal tabs (90°) into
place.
1
2
1
Dashboard
2
Mounting sleeve
3 Install the unit as illustrated.
1
2
3
4
5
1 Nut
2 Firewall or metal support
3
Metal strap
4
Screw
5
Screw (M4 × 8)
#
Make sure that the unit is installed securely in
place. An unstable installation may cause skipping
or other malfunctions.
Installation
8
Section
Installation
En
03