Pioneer DV-S737, Operating Insructions

Page: 10 / 64

10
Rear Panel
1
COMPONENT VIDEO OUT switch
You only need to set this switch if you’re using an
NTSC TV/monitor connected via the component
video outputs of this player. This player can output
NTSC video as a standard interlaced signal (the
525i(480i) setting), or as a non-interlaced, or
progressive scan signal (the 525p(480p) setting).
If your TV/monitor is compatible with progressive
scan video, set this switch to either
525p(480p) or
MENU SELECT . When set to MENU SELECT , you
can use the on-screen Setup menu to switch
between progressive and interlaced video output.
If your TV/monitor is not progressive scan
compatible, you will not be able to see any picture if
this player is set to output progressive scan video. In
this case, set the switch to
525i(480i) to restore the
picture.
2
COMPONENT VIDEO OUT jacks
(Interlace/Progressive-scan)
If your TV or monitor has component video inputs,
you can produce a higher quality picture on your TV
or monitor by connecting to the component video
outputs on this unit (
page 15 ).
3
D2 jack
(Interlace/Progressive-scan)
If your TV or monitor has D video input, you can
produce a higher quality picture on your TV or
monitor by connecting to the D2 video output on this
unit (
page 15 ).
4
S-VIDEO OUT jacks
If your TV or monitor has an S-video input, clear
picture reproduction is possible by connecting the
player to your TV or monitor via the S-Video jack
(
page 15 ).
You can switch between [S1] and [S2] S-video
output from the Setup menu ( page 31 ).
5
VIDEO OUT jacks
Connect to the video input on a TV or monitor or AV
amplifier or receiver with video input capability.
(
pages 13, 15 ).
6
AC IN power cord connection terminal
Use to connect the power cord to the wall outlet
(
page 13 ).
7
CONTROL IN/OUT jacks
Use to connect this player to another component
bearing the Pioneer
Î
mark. This lets you control
this unit as though it were a component in a system.
Player operations are then performed by pointing the
remote control at the component that the player is
connect to (
page 16 ).
8
DIGITAL OUT jack (optical (OPT))
Use to output the digital audio signal recorded on
discs. You can output the digital signal via either
optical output jack to an AV amplifier or receiver
(
page 14 ).
9
DIGITAL OUT jack (coaxial (COAX))
Use to output the digital audio signal recorded on
discs. You can output the digital signal via either
coaxial output jack to an AV amplifier or receiver
(
page 14 ).
0
TV SYSTEM switch*
(except for Taiwan model)
Use to change the TV signal mode to either PAL or
NTSC according to the type of TV and disc to be
used. When the switch is in the AUTO position, the
player outputs the format on the disc as is ( page 16 ).
-
AUDIO OUT jacks
Use to output two-channel audio (analog) to the
audio stereo inputs on a TV or stereo amplifier. If you
are connecting to a receiver that has both digital and
analog input jacks for DVD player connection, it may
be beneficial to make both connections (
pages 13,
14 ).
R L
Y
P
B R
P
525i
(480i)
525p
(480p)
MENU
SELECT
COAX
AUTO
NTSC
PAL
OPT
AC IN
AUDIO OUT
S-VIDEO OUT
D2
CONTROL TV SYSTEM DIGITAL OUT
IN OUT
COMPONENT VIDEO OUT
1
1
2
2 1 2
1
2
VIDEO OUT
1 2 4 5 3 6
7 8 0 - 9
*
*
TV SYSTEM switch is not present on Taiwan model.