10
En
•
The cords must not cover up the area
shown in the figure below. This is
necessary to allow the amplifiers to
radiate freely.
Do not cover this area
Installation tips
The following procedure describes how to
use the supplied parts to install this
product with the LCD screen attached to
the unit. It is also possible to install this
product so that the LCD screen is separate
from the unit. For details, visit the Pioneer
website for your region.
For some types of vehicles, it is necessary
to use an installation kit (sold separately)
when installing. For details, visit the
Pioneer website for your region.
1
First attach the supplied side brackets
to the LCD screen (
), then attach
them to this unit (
). After that,
connect the monitor cable to the LCD
screen (
).
Side bracket (for attaching LCD
screen to unit)
Binding head screw (5 mm)
Be sure to use the screws supplied
with this product.
Monitor cable
Attach the monitor cable to the unit
with heat resistant tape (sold
separately).
2
Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw
holes are aligned with the screw holes
of the bracket, and tighten the screws at
three locations on each side.
Installation using the screw
holes on the side of this
product
Leave ample
space
5 cm
5 cm
TIP
The amount of this unit's protrusion from
the dashboard/console can be adjusted by
shifting the position of the screw hole of
this unit to the factory radio-mounting
bracket.
Factory radio-mounting bracket
If the pawl interferes with
installation, you may bend it down
out of the way.
Dashboard or console
Binding head screw (8 mm)
Be sure to use the screws supplied
with this product.
•
Install the microphone in a place where
its direction and distance from the driver
make it easiest to pick up the driver’s
voice.
•
Be sure to turn off (ACC OFF) the product
before connecting the microphone.
•
Depending on the vehicle model, the
microphone cable length may be too
short when you mount the microphone
on the sun visor. In such cases, install the
microphone on the steering column.
1
Fit the microphone lead into the
groove.
Microphone lead
Groove
2
Attach the microphone clip to the sun
visor.
Microphone clip
Clamps
Use separately sold clamps to secure
Installing the
microphone
Mounting on the sun
visor
