En
gl
ish
- 45 -
[Factory Reset]
Touch [OK] to restore the settings to the default settings.
CAUTION
Do not turn off the engine while restoring the settings.
NOTES
•
This setting is available only when you stop your vehicle in a safe
place and apply the parking brake.
•
The source is turned off and the Bluetooth connection is
disconnected before the process starts.
•
Before starting the restore process, disconnect any device that is
connected to the USB port. Otherwise, some settings may not
be restored correctly.
[Connection Status]
Check that the leads are properly connected between this
product and vehicle.
[GPS Antenna]
Displays the connection status of the GPS antenna ([OK] or
[NOK]) and the reception sensitivity.
NOTE
If reception is poor, change the installation position of the GPS
antenna.
[Positioning Status]
Displays the positioning status (3D positioning, 2D
positioning, or no positioning), the number of satellites
used for positioning (orange), and the number of satellites
that have received signals (yellow). If signals from more
than six satellites are received, the current location can be
measured.
[Installation]
Indicates whether the inertial navigation is successfully
learned. If the learning is successful, [OK] will appear. If the
learning is not successful or due to failure after the
learning is successful, [NOK] will appear.
NOTE
If this product is not firmly fixed into place or the speed pulse wire
is not connected or properly connected, [NOK] is displayed due to
the learning failure.
[Speed Pulse]
The speed pulse value detected by this product is shown.
NOTE
Check that the speed pulse wire is properly connected if [0] is still
displayed while driving.
[Back Signal]
When the shift lever is shifted to “R” (reverse position), the
signal switches to [High] or [Low]. The signal displayed
varies depending on the vehicle.
Menu Item
Description
