14
En
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*3 Not available when [OFF] is selected in [SUB.W].
You can also access to these menus when the unit is turned off.
SUB.W CTRL
*2*3
Cut-off frequency:
[50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Output level:
[–24] to [+6]
Slope level:
[–12], [–24]
Only frequencies lower than those in the
selected range are output from the subwoofer.
BASS BOOST
[0] to [+6]
Select the bass boost level.
HPF SETTING
Cut-off frequency:
[OFF], [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Slope level:
[–12], [–24]
Only frequencies higher than the high-pass filter
(HPF) cutoff are output from the speakers.
SLA
[+4] to [–4]
Adjust the volume level for each source except
FM.
Each of the below combinations are set to the
same setting automatically.
•
USB, iPod, ANDROID, and APP (iPhone)
•
BT AUDIO, ANDROID, and APP (Android)
SYSTEM settings
Menu Item
Description
CLOCK SET
Set the clock (page 5).
12H/24H
[12H], [24H]
Select the time notation.
INFO DISPLAY
(Only for DEH-X6890BT)
Display the item on the sub information display.
Select from “SPEANA”, “LEVEL METER”, “SOURCE”,
“CLOCK”, and “OFF”.
Menu Item
Description
AUTO PI
[ON], [OFF]
Search for a different station with the same
programming, even if using a preset station.
AUX
[ON], [OFF]
Set to [ON] when using an auxiliary device
connected to the unit.
USB AUTO
[ON], [OFF]
Select [ON] to automatically switch to [USB]
source when a USB device/iPod is connected to
the unit.
Select [OFF] when a USB device/iPod is being
connected to the unit just for charging.
BT AUDIO
[ON], [OFF]
Set the Bluetooth signal on/off.
BT MEM CLEAR
[YES], [CANCEL]
Clear the Bluetooth device data (device list, PIN
code, call history, phone book, preset phone
numbers) stored in the unit.
[CLEARED] appears when data is successfully
deleted.
BT VERSION
Displays the system version of the unit and the
Bluetooth module.
APP CONN.SET
[WIRED], [BLUETOOTH]
Select the appropriate connection method
according to your device.
ANDROID WIRED
[MEMORY], [APP CONTROL]
Select the appropriate connection method for an
Android device.
•
This setting is not available when [BLUETOOTH]
is selected in [APP CONN.SET].
P.APP AUTO ON
[ON], [OFF]
Select [ON] to automatically launch the car remote
application when an Android device is connected
to the unit via AOA. (Not available when
[MEMORY] is selected in [ANDROID WIRED].)
Menu Item
Description
