Pioneer DDJ-SX3, Quick Start Manual

Page: 7 / 20

En
7
Before
start
About installing the driver software into
macOS High Sierra 10.13
For macOS High Sierra 10.13, the new security function is added.
When installing Pioneer DJ driver software into macOS High Sierra
10.13, the driver software authentication is required. Follow the
procedures below.
Following procedures are necessary when newly installing the driver
software into macOS High Sierra 10.13.
If the driver software has been installed into macOS or OS X before
updating to macOS High Sierra 10.13, following procedures are not
necessary.
When installing Pioneer DJ driver software into macOS High Sierra
10.13, the following screen is displayed.
Click [ OK ].
After permitting the driver software installation, the driver software
installing will be completed.
1 Open [System Preferences], and then click [Security
& Privacy].
2 Check that [System software from developer “Pioneer
DJ Corporation” was blocked from loading.] is displayed
on the lower screen.
This is shown for 30 minutes from starting the driver software
installation.
If it is not shown, repeat the procedure of the driver software installation.
3 Click [Allow] on the lower-right screen.
4 If the DJ equipment is connected to Mac, disconnect
the USB cable, and then connect it again.
About the AC adapter
Safety instructions
!
Do not use this unit with a coin, paper clip or other metal object
stuck between the AC adapter and power plug. Doing so could cause
a short circuit, leading to fire or electric shock.
!
When mounting the AC adapter on a wall outlet, make sure there is
no space between the AC adapter and the wall outlet. Faulty contact
or a coin, paper clip or other metal object getting stuck in the space
could cause a short circuit, leading to fire or electric shock.
Coin, paper clip or other metal object
Top
Side
! The power plug could come detached from the AC adapter and
remain in the power outlet if someone trips on the AC adapter’s
power cord or if something hits the AC adapter. If this happens,
remove the power plug remaining in the outlet with dry hands,
holding it as shown on the diagram below and without touching
metal parts. Do not use any tools to remove it.
Do not touch.