32
DDJ-ERGO-V
1
2
3
4
A
B
C
D
E
F
1
2
3
4
Confirming the Firmware Version (MAIN_UCOM) and Confirming the Mode setting
(VINYL mode and jog dials' illumination mode)
1
Integral part of the version number
(LEDs on DECK A lit)
[Numerics expressed with the number of lit LEDs]
To enter this mode, while simultaneously holding the DECK A and KEYLOCK buttons on the Deck A/C side pressed, set the
Power switch of the unit to O
N
.
(Hold the two buttons pressed until the opening display terminates.)
The version number of the firmware (MAI
N
_UCOM) will be indicated with LED-lighting patterns that are switched every
3 seconds in integral part and decimal fraction part.
In the blocks that are indicated with the red frames in the figures, the number of lit LEDs indicates the corresponding number.
In addition to the above-mentioned firmware-version indication, the setting statuses of
V
I
N
YL mode and Illumination mode
for the Jog dial are indicated with other LEDs.
* For details, see “6.4 FACTORY RESET MODE.”
x
. xx
2
Decimal fraction part of the version number
(LEDs on DECKs A and B lit)
x
.
xx
0
1
2
3
4
5
6
7
8
9
3 sec
Mode
Point
Mode setting state
LED display
V
I
N
YL mode
DECK A/C
DECK B/D
O
N
V
I
N
YL LED on the DECK A/C side lit
OFF
V
I
N
YL LED on the DECK A/C side unlit
O
N
V
I
N
YL LED on the DECK B/D side lit
OFF
V
I
N
YL LED on the DECK B/D side unlit
Illumination mode
JOG dial
Pulse Mode: Active
Blue LEDs on both decks lit
Pulse Mode:
N
ormal
Blue LEDs on both decks unlit
