16
CX-961
1. The centering guide is supported on the shaft at the
clamp arm rear part and the front part is energized to
the bottom.
2. For an 8-cm disk, the disk is centered at the position
where it runs against the centering guide front part as
is, and clamp operation occours.
3. For a 12-cm disk, the centering guide front is held by
the centering guide relief arm. The disk passes through
under it and is centered at the mechanical unit depth
position, and clamp operation occours.
-
Clamp operation
1. 8-cm and 12-cm disks drive the detection arm at the
centered position on the spindle, and start the disk
clamp operation by engaging the rack arm and drive
gear.
2. The mechanical unit lock lever moves to the arrow
view direction and releases the coupling between the
mechanical unit lock arm and frame. Further, it
completes clamp operation at the position where the
clamp SW is set to ON.
-
Ejection operation
1. The loading motor rotates backward and the ejection
operation starts.
2. A 12-cm disk completes ejection operation when
SW3 is set from OFF to ON to OFF in this order.
3. An 8-cm disk completes ejection operation when
SW2 is set from OFF to ON to OFF in this order.
Centering Guide
Detection Lever
Rack Arm
Drive Gear
Mechanical Unit Lock Lever
Mechanical Unit Lock Arm
Clamp SW
SW3
SW2
8cm
12cm
Detection Arm
Frame
