44
CDX-P1270
7.1.2 DISASSEMBLY
-
Removing the Power Unit (Fig.6)
Remove the two screws.
Remove the screw.
Straight the tabs at location indicated
and then remove the Power Unit.
-
Removing the Upper Case (not shown)
1. Remove the nine screws.
2. Remove the Upper Case.
-
Removing the CD Mechanism Module
(Fig.5)
Remove the four dampers.
Remove the two springs.
Disconnect the connector and then remove
the CD Mechanism Module.
Fig.6
CD Mechanism Module
Fig.5
Power Unit
-
Removing the Door
1. Remove the Door(A) in the direction of arrow
2
while
pushing the Grille in the direction of arrow
1
, the slide
is done as it is in the direction of arrow
3
and remove
the Door(A). (Fig.7)
Fig.7
Door(A)
Grille
Summary of Contents for CDX-P1270
