Buttons on Remote Control
Problem solving hints and tips
Please check the list below. If the problem can’t be solved, please contact your local dealer
or a qualified professional.
Problem
Possible cause
Possible solution
Your remote
control isn’t
working or the
unit can’t receive
its signal?
Your remote control may have been
affected by static electricity or a surge
in voltage.
Pull out the plug. Reinsert the
plug after about three minutes
and restart the unit.
Is your remote control within the signal
receiving range?
Signal receiving range is eight
metres.
Your remote control signal is blocked
by obstacles.
Remove any obstacles and try
again.
Is your remote control pointing directly
at the receiving window?
Point the remote control directly
at the receiving window on your
unit.
Your remote control’s sensitivity is low
or the display is fuzzy or empty.
Check the batteries and replace
if needed.
No display when
operating remote control?
Replace batteries. Or if remote
control is damaged, you may
need to replace it.
Do you have a fluorescent lamp in the
room?
Turn off the fluorescent lamp.
Take the remote control closer
to the unit and try again.
No air emits
from indoor
unit.
The air inlet or air outlet of the outdoor
unit could be blocked.
Check for obstacles and
remove.
Has your unit reached a set
temperature in heating mode?
After reaching a set
temperature, the unit will stop
blowing out air.
You’ve just this minute turned air
conditioner/heat pump on.
In order to prevent blowing out
immediate cold air, there will be
a delay of several minutes
every time your unit starts up.
Air conditioner
isn’t operating at
all
Power failure.
Wait unit power recovery.
Is it plugged in properly?
Reinsert the plug.
Circuit break trips off or a fuse is burnt
out.
Seek professional help to
replace circuit break or fuse.
Wiring problems.
Seek professional help to
replace it.
Unit has restarted immediately after
stopping operation?
Wait for three minutes and then
turn the unit on again.
The function setting on you- remote
control may not be correct.
Reset the function.
Summary of Contents for Blade HPR-09A2
Page 8: ...Remote control Display Wi Fi Temp indicator Power indicator ...
Page 10: ......
