Installation
Note:
•
Before finally installing this product, connect the
wiring temporarily, making sure it is all connect-
ed up properly, and this product and the system
work properly.
•
Use only the parts included with this product to
ensure proper installation. The use of unautho-
rized parts can cause malfunctions.
•
Consult with your nearest dealer if installation
requires the drilling of holes or other modifica-
tions of the vehicle.
•
Install this product where it does not get in the
driver’s way and cannot injure the passenger if
there is a sudden stop, like an emergency stop.
•
Do not place the display in a position where it
will impede the driver’s visibility or affect the
operation of your vehicle’s air bags.
•
The semiconductor laser will be damaged if it
overheats, so don’t install the unit anywhere hot
— for instance, near a heater outlet.
•
If installation angle exceeds 30° from horizontal,
this product might not give its optimum perfor-
mance.
DIN Front/Rear-mount
This product can be properly installed either
from “Front” (conventional DIN Front-mount) or
“Rear” (DIN Rear-mount installation, utilizing
threaded screw holes at the sides of product chas-
sis). For details, refer to the following illustrated
installation methods.
DIN Front-mount
7
Installation with the rubber bush
7
Removing this product
Pull out to remove the frame.
(When reattaching the frame, point the side with
a groove downwards and attach it.)
Continued overleaf.
Frame
182
53
Holder
After inserting the holder into the dash-
board, then select the appropriate tabs
according to the thickness of the dash-
board material and bend them.
(Install as firmly as possible using the
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
Rubber bush
Screw
Dashboard
30
°
28
ENGLISH
ESPA
Ñ
OL
DEUTSCH
FRAN
Ç
AIS
ITALIANO
NEDERLANDS