Pioneer AVIC-X1R Installation Manual Download Page 5

Page: 5 / 181

<CRD3958A/U> 5

English

Español

Deutsch

Français

Italiano

Nederlands

ENG/MASTER 96

Connecting the System

• Pioneer does not recommend that you install your Navigation System yourself. We

recommend that only authorised Pioneer service personnel, who have special train-
ing and experience in mobile electronics, set up and install the unit. NEVER SER-
VICE THE UNIT YOURSELF. Installing or servicing the unit and its connecting
cables may expose you to the risk of electric shock or other hazards, and can cause
damage to the Navigation System that is not covered by warranty.

• If you decide to perform the installation yourself, and have special training and

experience in the mobile electronics installations, please carefully follow all of the
steps in the Installation Manual.

• Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring

to remain exposed.

• Do not directly connect the yellow lead of the unit to the vehicle battery. If the lead

is directly connected to the battery, engine vibration may eventually cause the insu-
lation to fail at the point where the wire passes from the passenger compartment
into the engine compartment. If the yellow lead’s insulation tears as a result of con-
tact with metal parts, short-circuiting can occur, resulting in considerable danger.

• It is extremely dangerous to allow the GPS aerial cable or microphone cable to

become wound around the steering column or gearstick. Be sure to install the unit,
its cables, and wiring away in such a way that they will not obstruct or hinder dri-
ving.

• Make sure that the cables and wires are routed and secured so they will not inter-

fere with or become caught in any of the vehicle’s moving parts, especially the
steering wheel, gearstick, handbrake, sliding seat tracks, doors, or any of the vehi-
cle’s controls.

• Do not route wires where they will be exposed to high temperatures. If the insula-

tion heats up, wires may become damaged, resulting in a short circuit or malfunc-
tion and permanent damage to the product.

• Do not cut the GPS aerial cable to shorten it or use an extension to make it longer.

Altering the aerial cable could result in a short circuit or malfunction.

• Do not shorten any leads. If you do, the protection circuit (fuse holder, fuse resister

or filter, etc.) may fail to work properly.

• Never feed power to other electronic products by cutting the insulation of the

power supply lead of the Navigation System and tapping into the lead. The current
capacity of the lead will be exceeded, causing overheating.

• Do not earth more than one product together with the earth from another product.

For example, you must separately earth any amplifier unit away from the earth of
the Hide-away unit. Connecting earths together can cause a fire and/or damage the
products if their earths became detached.

CRD3958A_U_inst001_031_UK 11/12/04 13:09 Page 5