Black plate (27,1)
!
The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps and navigation mechanism
to dissipate heat.
Do not cover this area.
!
The semiconductor laser will be damaged
if it overheats, so don
’
t install this product
anywhere hot
—
for instance, near a heater
outlet.
Parts supplied
Parts marked (*) are pre-installed.
This product
Holder*
Truss head screw
(5 mm × 8 mm)
(6 pcs.)
Flush surface screw
(5 mm × 9 mm)
(6 pcs.)
Trim ring*
Extraction Key
(2 pcs.)
Before installing this product
1
Remove the trim ring.
Extend top and bottom of the trim ring out-
wards to remove the trim ring.
1
1
Trim ring
2
Insert the supplied extraction keys into
both sides of the unit until they click into
place.
3
Pull the unit out of the holder.
1
1
Extraction key
Installation with the holder
1
Install the holder into the dashboard.
2
Secure the mounting sleeve by using a
screwdriver to bend the metal tabs (90°)
into place.
1
2
<CRD4952-B>27
Engb
27
English
Section
03
Installation
