19
Installation
Installing this product
Installation notes
• Do not install this product in places where it may become subject to high temperatures
or humidity, such as:
* places close to a heater, vent or air conditioner.
* places exposed to direct sunlight, such as on top of the dashboard.
* places that may be splashed by rain, for example close to the door.
• Install this product in an area strong enough to bear its weight. Choose a position where
this product can be firmly installed, and install it securely.
If this product is not securely installed, the current location of the vehicle cannot be dis-
played correctly.
• Install this product horizontally on a surface within 0 degrees to 30 degrees tolerance. If
the installation angles on the left and right sides exceed 5 degrees, the allowable range
can be increased to 10 degrees by making corrective adjustments. (Refer to “Correcting
the installation angle” in the Operation Manual.) If connection of the pink lead (CAR
SPEED SIGNAL INPUT) is omitted, the angles on the left and right sides are allowable
to within five degrees. Improper installation of the unit with the surface tilted more than
these tolerances increases the potential for errors in the location display, and might oth-
erwise cause reduced display performance.
• The cords must not cover up the area shown in the figure below. This is necessary to
allow the amplifiers and navigation mechanism to heat dissipate freely.
• The semiconductor laser will be damaged if it overheats, so don’t install this product
anywhere hot — for instance, near a heater outlet.
Do not cover this area.
If the angle exceeds five degrees,
please make corrective adjustments.
ENG/MASTER 96
<CRD4067A/U> 20
CRD4067A_U_inst_001_027_US 10/24/05 19:49 Page 20
