18
17
Installation
ENG/MASTER 96
DIN Front/Rear-mount
This unit can be properly installed either from “Front” (conventional DIN Front-mount) or
“Rear” (DIN Rear-mount installation, utilising threaded screw holes at the sides of unit
chassis). For details, refer to the following illustrated installation methods.
DIN Front-mount
Installation with the rubber bush
Removing the Unit
After inserting the holder into the dash-
board, then select the appropriate tabs
according to the thickness of the dash-
board material and bend them.
(Install as firmly as possible using the
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
182
53
Rubber bush
Screw
Dashboard
Holder
Pull out to remove the frame.
(When reattaching the frame, point the
side with a groove downwards and
attach it.)
Frame
Insert the supplied extrac-
tion keys into the unit, as
shown in the figure, until
they click into place.
Keeping the keys pressed
against the sides of the unit,
pull the unit out.
CRD3647A_inst_001_029_UK 4/15/02 2:03 PM Page 18
